LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 705 (Electronic Engine Control System - F-150 & Mark LT) >> Removal And Installation >> Fuel Rail Pressure and Temperature Sensor - 5.4L (3V) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the fuel system pressure. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.
  2. Disconnect the fuel rail pressure and temperature sensor electrical connector.
  3. Disconnect the fuel rail pressure and temperature sensor vacuum connector.
  4. Remove the bolts and the fuel rail pressure and temperature sensor.
    • To install, tighten to 4 Nm (35 lb-in).
  5. Remove and discard the O-ring seal.
    • Install a new O-ring seal and lubricate it with clean engine oil.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals