Pinpoint Test C: The Steering Wheel Control Illumination Is Inoperative
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- C1 CHECK THE HORN OPERATION
- Check the operation of the horn by pressing the horn pad.
- Does the horn operate correctly?
Yes: GO to C2.
No: REFER to HORN to continue diagnosis of the horn.
- C2 CHECK CIRCUIT 1417 (LG/RD) FOR AN OPEN
- Key in OFF position.
- Depower the supplemental restraint system (SRS). Refer to DEPOWERING PROCEDURE .
- Disconnect: Clockspring C2274a.
- Key in ON position.
- Place the headlamp switch to the parking lamps ON position.
- Rotate the instrument panel dimmer switch to the full illumination position.
- Measure the voltage between the clockspring C2274a-3, circuit 1417 (LG/RD), harness side and ground.
- Is the voltage greater than 10 volts?
Yes: TURN the headlamp switch off. GO to C3.
No: REPAIR the circuit. REPOWER the SRS. REFER to REPOWERING PROCEDURE . TEST the system for normal operation.
- C3 CHECK THE CLOCKSPRING FOR AN OPEN
- Key in OFF position.
- Remove the driver air bag module. Refer to REMOVAL .
- Disconnect: Upper Clockspring 5-Pin Connector.
- Measure the resistance between the clockspring C2274a pin 3, component side and the upper clockspring 5-pin connector pin 1, component side.
- Is the resistance less than 5 ohms?
Yes: INSTALL new steering wheel controls. REFER to REMOVAL AND INSTALLATION or REMOVAL AND INSTALLATION as necessary. INSTALL the driver air bag module. REFER to INSTALLATION . TEST the system for normal operation.
No: INSTALL a new clockspring. REFER to INSTALLATION . INSTALL the driver air bag module. REFER to INSTALLATION . TEST the system for normal operation.