LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1143 (Acceleration Control 6.0L (99P E-Series) Diesel) >> Removal And Installation >> Accelerator Pedal >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The red clip must be pulled out before disconnecting the electrical connector.
  1. Disconnect the accelerator pedal position (APP) sensor electrical connector.
  2. Remove the 2 bolts and slide the accelerator pedal and position sensor assembly up and off the anchor bolt.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals