Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the splash shield.
Remove the accessory drive belt from the pulley.

Fig 1: Rotating Drive Belt Tensioner Clockwise

Courtesy of FORD MOTOR CO.

Disconnect and detach the crankshaft position (CKP) sensor electrical connector and position the wiring harness aside.
Detach the wiring harness from the bracket.

Fig 2: Locating Wiring Harness Bracket

Courtesy of FORD MOTOR CO.

Disconnect the A/C compressor electrical connector.

NOTE: It is not necessary to remove the A/C compressor bolts.

Loosen the bolts enough to slide the A/C compressor down 25.4 mm (1 in), allowing access for CKP sensor removal.
- To install, tighten to 25 Nm (18 lb-ft).
Remove the CKP sensor bolt and the CKP sensor. Inspect the O-ring seal for damage and replace if necessary.
- Lubricate the O-ring seal with clean engine oil prior to installation.
- To install, tighten to 10 Nm (89 lb-in).
To install, reverse the removal procedure.