Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: RH shown, LH similar.

Insert an appropriate tool into the slot and release the detachable safety belt anchor from the seat.

Fig 1: Inserting Appropriate Tool Into Slot & Releasing Detachable Safety Belt Anchor From Seat

Courtesy of FORD MOTOR CO.

Remove the seat.
- Pull the seat latch release handle, slide the seat to the right and disengage from the latch striker plate.

Fig 2: Pulling Seat Latch Release Handle, Sliding Seat To Right & Disengaging From Seat Latch Striker

Courtesy of FORD MOTOR CO.

Remove the 4 bolts and seat latch striker.
- To install, tighten to 90 Nm (66 lb-ft).
To install, reverse the removal procedure.