LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1035 (Electronic Engine Control System - 2.3L - (Except Hybrid)) >> Removal And Installation >> Idle Air Control (IAC) Valve >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3 screws, the pin-type retainer and the upper and lower snow shield.
    • To install, tighten to 10 Nm (89 lb-in).
  2. Disconnect the idle air control (IAC) valve electrical connector.
  3. Remove the 2 bolts and the IAC valve.
    • To install, tighten to 10 Nm (89 lb-in).
    • Inspect the gasket and install new as necessary.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals