Removal and Installation
WARNING: This page is about a different variant/trim than selected.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
- Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- Drain the motor electronics cooling system. For additional information, refer to TRANSAXLE-TRANSMISSION COOLING - HYBRID .
- Disconnect the motor electronics coolant vent hose.
- Disconnect the 2 engine coolant vent hoses.
- Remove the degas bottle bolt and nut.
- To install, tighten the nut to 6 Nm (53 lb-in) and the bolt to 8 Nm (71 lb-in).
- Lift the degas bottle up and disconnect the engine coolant and motor electronics coolant return hoses.
- Remove the degas bottle.
- To install, reverse the removal procedure.
- Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- Fill and bleed the motor electronics cooling system. For additional information, refer to TRANSAXLE-TRANSMISSION COOLING - HYBRID .