LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.3L - (Hybrid)) >> In-Vehicle Repair >> Valve Cover >> Removal

Valve Cover: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the ignition coil-on-plugs. For additional information, refer to ENGINE IGNITION - 2.3L .
  3. Disconnect the crankcase vent hose.
  4. Remove the 3 engine cover studs.
  5. Disconnect the camshaft position (CMP) sensor electrical connector.
  6. Disconnect the fuel rail pressure and temperature sensor electrical connector.
  7. Disconnect the cylinder head temperature (CHT) sensor electrical connector.
  8. Remove the 14 valve cover retainers, the valve cover and gasket.
scientia non olet · About LEMON Manuals