LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.3L - (Hybrid)) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the 5 bolts and the RH splash shield.
    • To install, tighten to 9 Nm (80 lb-in).
  3. Remove the lower oil level indicator tube bolt.
    • To install, tighten to 47 Nm (35 lb-ft).
  4. Remove the oil level indictor.
  5. Remove the upper bolt and the oil level indicator tube.
    • To install, tighten to 10 Nm (89 lb-in).
  6. Remove and discard the oil level indicator tube O-ring seal.
  7. To install, reverse the removal procedure.
    • Lubricate a new O-ring seal with clean engine oil.
scientia non olet · About LEMON Manuals