In-Vehicle Repair: Flywheel: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Special bolts are used for installation. Do not use standard bolts.

Install the flywheel and tighten the bolts in the sequence shown in Fig 1 in the following 3 stages:
- Stage 1: Tighten to 50 Nm (37 lb-ft).
- Stage 2: Tighten to 80 Nm (59 lb-ft).
- Stage 3: Tighten to 112 Nm (83 lb-ft).
  
  Fig 1: Installing Flywheel And Tightening Bolts
  Courtesy of FORD MOTOR CO.
Install the engine. For additional information, refer to ENGINE .