LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Engine Controls - Pinpoint Tests - (Hybrid)) >> TP: Traction Motor Overspeed >> Test Procedures

Test Procedures

WARNING: This page is about a different variant/trim than selected.
  1. TP1 CONTINUOUS MEMORY DTC P0A44: CHECK FRO CORRECT CORRECTION MOTOR RPM DURING THE ROAD TEST 
    NOTE: Refer to the VEHICLE SPEED KM/H (MPH)/TRACTION MOTOR RPM CHART  at the beginning of this pinpoint test for correct traction motor to vehicle speed correlations.
    • Clear the TCM DTCs.
    • Access the TCM and monitor the VSS and M_SPEED PIDs.
    • Road test the vehicle.
    • Record traction motor RPM at different vehicle speeds  .

    Does the traction motor RPM correspond with the vehicle speed? 

    Yes No
    Unable to duplicate or identify the fault at this time.
    RETURN to SYMPTOM CHARTS - HYBRID ESCAPE to continue diagnosis.
    INSTALL a new transaxle assembly.