LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Engine Controls - Pinpoint Tests - (Hybrid)) >> QC: DTC P1000: On Board Diagnostic (OBD) Systems Readiness Test Not Complete >> Test Procedures

Test Procedures

WARNING: This page is about a different variant/trim than selected.
  1. QC1 CONTINUOUS MEMORY DTC P1000: CHECK FOR ANY OTHER DTCS 
    NOTE: Carry out this pinpoint test only if a Diagnostic Trouble Code DTC P1000 was received from Continuous Memory. Ignore any DTC P1000s in KOEO or KOER.
    • DTC P1000 indicates all of the OBD monitors have not yet been successfully tested.

    Are any other DTCs received with P1000? 

    Yes No
    DISREGARD the current diagnostic trouble code (DTC) at this time. ADDRESS the next DTC. GO to DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONS . GO to  QC2.
  2. QC2 REQUEST TO CLEAR DTC P1000 
    NOTE: An entire OBD drive cycle has not yet been completed to clear DTC P1000 from the PCM.

    Has the customer requested DTC P1000 be cleared from the PCM memory? 

    Yes No
    CARRY OUT an OBD drive cycle. REFER to ON BOARD DIAGNOSTIC (OBD) DRIVE CYCLE . Key in OFF position.
    INFORM the customer that if the law in your area requires additional driving in order to clear DTC P1000 from the PCM memory, it must be completed before an inspection/maintenance test.
scientia non olet · About LEMON Manuals