DTC P1A08: Generator Mode Signal
WARNING: This page is about a different variant/trim than selected.
P1A08 - GENERATOR MODE SIGNAL
| Description: | The TCM continuously monitors the CAN network for a generator mode message from the PCM. This DTC is set when the received message does not match the actual generator mode. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Monitor the GENMODE PID. The PID state ERROR indicates a hardware malfunction. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test TI . | - | GO to Pinpoint Test TI . |