DTC P1719: Engine Torque Signal
WARNING: This page is about a different variant/trim than selected.
P1719 - ENGINE TORQUE SIGNAL
| Description: | The TCM continuously monitors the CAN network for an engine torque message from the PCM. This DTC is set when the engine torque is not within the expected range. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Read the ENG_TQ TCM PID. The PID value should not exceed 194 Nm (143 lb ft) with KOEO, and with the transaxle gear selector in PARK. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test TW . | - | GO to Pinpoint Test TW . |