DTC P1145: (TCM) - Calculated Torque Error
WARNING: This page is about a different variant/trim than selected.
P1145 (TCM) - CALCULATED TORQUE ERROR
| Description: | The TCM continuously monitors the CAN network for calculated torque message from the PCM. This DTC is set when the calculated torque is not within the expected range. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Read the TCM TQ_DSD PID. The PID value should be positive in DRIVE or LOW, negative in REVERSE, 0 Nm (0 lb ft) in PARK or NEUTRAL if the brake pedal is not applied. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test TU . | - | GO to Pinpoint Test TU . |