DTC P0A44: Drive Motor A Position Sensor Circuit OVERSPEED
WARNING: This page is about a different variant/trim than selected.
P0A44 - DRIVE MOTOR A POSITION SENSOR CIRCUIT OVERSPEED
| Description: | Indicates the transaxle traction motor exceeded its calibrated maximum RPM limit. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Road test the vehicle. The traction motor should not exceed 8,780 RPM at 109 km/h (68 mph). | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | - | - | GO to Pinpoint Test TP . |