DTC P0443: EVAP Control System Canister Purge Valve Circuit Malfunction

WARNING: This page is about a different variant/trim than selected.

P0443 - EVAP CONTROL SYSTEM CANISTER PURGE VALVE CIRCUIT MALFUNCTION

Description:	The PCM monitors the state of the EVAP canister purge valve circuit output driver. The test fails when the signal moves outside the minimum or maximum limit for the commanded state.
Possible Causes:	VPWR circuit open. EVAP canister purge valve circuit shorted to GND. Damaged EVAP canister purge valve. EVAP canister purge valve circuit open. EVAP canister purge valve circuit shorted to VPWR.
Diagnostic Aids:	To verify normal function, monitor the electronic vapor management valve signal PID EVMV and the signal voltage (PCM control side). With the valve closed (0%), the EVMV PID indicates 0 mA and voltage is approximately equal to battery voltage. When the valve is commanded fully open (100%), EVMV PID indicates 1,000 mA and a voltage drop of 3 volts minimum is normal. Output state control (OSC) may be used to switch output on/off to verify function.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to Pinpoint Test HX .