LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (Engine Controls - Powertrain DTC Charts And Description - (Hybrid)) >> Diagnostic Trouble Code (DTC) Charts and Descriptions >> DTC P0192: Fuel Rail Pressure (FRP) Sensor Circuit Low Input

DTC P0192: Fuel Rail Pressure (FRP) Sensor Circuit Low Input

WARNING: This page is about a different variant/trim than selected.
P0192 - FUEL RAIL PRESSURE (FRP) SENSOR CIRCUIT LOW INPUT

Description:  The comprehensive component monitor (CCM) monitors the FRP sensor circuit to the PCM for low voltage. If voltage falls below a calibrated limit and a calibrated amount of time during testing, the test fails.
Possible Causes: 
  • FRP signal shorted to SIG RTN or PWR GND.
  • Damaged FRP sensor.
  • VREF circuit open.
  • VREF circuit shorted to GND or SIGRTN.
  • Damaged PCM.
Diagnostic Aids:  An FRP PID value less than 0.3 volt during KOEO or KOER indicates a hard fault.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to Pinpoint Test DD .
scientia non olet · About LEMON Manuals