DTC P0191: Fuel Rail Pressure (FRP) Sensor Circuit Performance
WARNING: This page is about a different variant/trim than selected.
P0191 - FUEL RAIL PRESSURE (FRP) SENSOR CIRCUIT PERFORMANCE
| Description: | The comprehensive component monitor (CCM) checks the FRP for acceptable fuel pressure. The test fails when the fuel pressure falls below or exceeds a minimum/maximum calibrated value for a calibrated period of time. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | The FRP PID value during KOER should be between 275 kPa (40 psi) and 485 kPa (70 psi). | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test DD . | ||