DTC P0122: Etc Throttle Position (TP1) Sensor Circuit Low Input
WARNING: This page is about a different variant/trim than selected.
P0122 - ETC THROTTLE POSITION (TP1) SENSOR CIRCUIT LOW INPUT
| Description: | The ETC TP1 sensor was flagged as fault status by the PCM indicating a low voltage or open circuit. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | The fault exhibits a symptom of limited power. A TP1 PID (TP V PID) reading less than 3.42% (0.17 volt) during KOEO or KOER indicates a hard fault. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test DV . | ||