Vehicle Preparation

WARNING: This page is about a different variant/trim than selected.

Carry out all safety steps required to start and run vehicle tests. Apply the parking brake, place the gear selector firmly into the PARK position and block the drive wheels.
Verify the high voltage traction battery state of charge (SOC) is equal to or greater than 45% by monitoring the traction battery control module (TBCM) SOC PID. If the monitored PID displays the SOC below 45%, start and idle the engine with full A/C ON.
Turn the A/C on and verify it functions correctly.
Turn off all electrical loads, such as radios, lamps, A/C, blower, and fans.
Start the engine and bring it up to the normal operating temperature before running the quick test.