Removal and Installation
WARNING: This page is about a different variant/trim than selected.
- Remove the auxiliary climate control housing. For additional information, refer to AUXILIARY CLIMATE CONTROL HOUSING .
- Remove the 2 battery zone valve screws.
- Loosen the nuts and disconnect the battery zone valve fittings.
- To install, tighten to 10 Nm (89 lb-in).
- Disconnect the electrical connector and remove the battery zone valve.
- To install, reverse the removal procedure.
NOTE:
New O-ring seals, lubricated in clean mineral oil, must be installed before reconnecting any A/C fitting which has been disconnected.