LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine - 2.3L - (Except Hybrid)) >> In-Vehicle Repair >> Engine Mount >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the engine coolant degas bottle. For additional information, refer to ENGINE COOLING .
  3. Install the special tool.
    Fig 1: Installing Special Tool (303-F072)
    G03897838Courtesy of FORD MOTOR CO.
  4. Remove the engine mount bracket bolt.
    • To install, tighten to 90 Nm (66 lb-ft).
  5. Use the special tool to raise the engine 25 mm (0.98 in).
    Fig 2: Raising Engine
    G03897838Courtesy of FORD MOTOR CO.
  6. Remove the 2 nuts and the engine mount bracket.
    • To install, tighten to 90 Nm (66 lb-ft).
  7. Remove the 3 bolts and the engine mount.
    • To install, tighten to 55 Nm (41 lb-ft).
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals