Max A/C

When MAX A/C is selected:

• The air inlet mode door receives a full vacuum signal, closing off outside air and allowing only recirculated air.
• The defrost air inlet mode door receives a full vacuum signal, while the floor mode door receives no vacuum, closing both doors.
• The panel mode door receives a partial vacuum signal, directing airflow to the driver side, passenger side and center registers.
• The temperature settings can be changed.
• Air is picked up at the recirculation air inlet by the blower motor. With the temperature control set for maximum cold, air flows across the front A/C evaporator core, is diverted past the heater core, and is then directed into the passenger compartment through the driver side, passenger side, and center registers.
• The PCM enables the A/C compressor.
• The gasoline engine runs continuously.
• The blower motor is ON.