Selector Lever Bezel: Installation

WARNING: This page is about a different variant/trim than selected.

Install the gearshift bezel.

Fig 1: Installing Gearshift Bezel
Courtesy of FORD MOTOR CO.
Feed the overdrive cancel switch electrical connector wire harness into the opening in the bezel and install the knob.

CAUTION: Do not overtighten the set screw or damage to the plastic straw will occur.

Fig 2: Locating Set Screw

Courtesy of FORD MOTOR CO.

Install the set screw.
Install the top finish panel.

Fig 3: Removing/Installing Top Finish Panel
Courtesy of FORD MOTOR CO.
Install the upper shift lever trim ring.
- To install the upper shift lever trim ring, orient the thick tab on the driver side front of the shifter and press into place.
  
  Fig 4: Identifying Upper Shift Lever Trim Ring
  Courtesy of FORD MOTOR CO.
Move the shifter through all gears from PARK to DRIVE several times making sure that the shift knob set screw is not too tight.