Section 24 (High Voltage Traction Battery)
WARNING: This page is about a different variant/trim than selected.
- Specifications
- Description And Operation
- Diagnosis And Testing
- High Voltage Traction Battery
- Notes
- Special Tool(s)
- Inspection and Verification
- Symptom Chart
- Pinpoint Test A: No Communication With The Traction Battery Control Module (TBCM)
- Pinpoint Test B: The High Voltage Traction Battery (HVTB) Is Noisy
- Pinpoint Test C: Radio Interference
- Pinpoint Test D: DTC P0A7E - Hybrid Battery Pack Over Temperature
- Pinpoint Test E: DTCs P0A81, P0A96 - Hybrid Battery Pack Cooling Fans 1 And 2 Control Circuits
- Pinpoint Test F: DTCs P0A8B, P0A8D, P0A8E - 14-Volt Power Module System Voltage
- Pinpoint Test G: DTC P0A27 - Hybrid Battery Power Off Circuit
- Pinpoint Test H: DTC C1862 - Contactor Circuit Failure
- Pinpoint Test I: DTC P0AA6 - Hybrid Battery Voltage System Isolation Fault
- Pinpoint Test J: DTC P0A1F - Battery Energy Control Module Has Internal Errors
- Pinpoint Test K: DTC P0A7D - Hybrid Battery Pack State Of Charge Low
- Pinpoint Test L: DTC B1016 - Jump Start Control Module Fault
- Pinpoint Test M: DTC P2533 - Ignition Switch Run/Start Position Circuit
- Pinpoint Test N: DTC B1143 - Excessive Battery Contactor Close Requests
- Component Tests
- High Voltage Traction Battery
- General Procedures
- Removal And Installation