LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Manual Transmission) >> In-Vehicle Repair >> Vehicle Speed Sensor (VSS) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
    2. NOTE: The electrical connector and the VSS are accessed from the top of the transaxle.
  2. Remove the VSS bolt.
  3. Disconnect the electrical connector and remove the VSS.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals