LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Manual Transmission) >> Disassembly And Assembly Of Subassemblies >> Differential - FWD >> Assembly

Differential - FWD: Assembly

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Be careful not to crush the bearing while pressing it onto the differential case.
    Fig 1: Pressing Differential Case
    G03901836Courtesy of FORD MOTOR CO.
  1. Install a new differential side bearing.
  2. Install the VSS drive gear.
  3. Install the spacer.
    4. CAUTION: Be careful not to crush the bearing while pressing it onto the differential case.
    Fig 2: Installing New Differential Side Bearing
    G03901837Courtesy of FORD MOTOR CO.
  4. Install a new differential side bearing.
  5. Install the final drive gear and the 10 bolts.
    • Tighten in sequence to 120 Nm (89 lb-ft).
      Fig 3: Installing Final Drive Gear And Bolts
      G03901838Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals