Gearshift Lever: Installation

WARNING: This page is about a different variant/trim than selected.

Position the gearshift lever.
Connect the select cable.

Fig 1: Connecting Select Cable
Courtesy of FORD MOTOR CO.
Connect the gearshift cable.

Fig 2: Connecting Gearshift Cable
Courtesy of FORD MOTOR CO.

CAUTION: Make sure the clips are set completely within the cable adapter groove and fully seated.

Fig 3: Installing Gearshift Cable Clips

Courtesy of FORD MOTOR CO.

Install the 2 gearshift cable clips.
Install the 4 gearshift lever bolts.
- Tighten to 25 Nm (18 lb-ft).
Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE-TRANSMISSION AND CLUTCH - GENERAL INFORMATION .
Install the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .