LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Manual Transmission External Controls) >> Removal And Installation >> Gearshift Cables >> Removal

Gearshift Cables: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the restraints control module (RCM). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
  2. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
    3. NOTE: Both gearshift cables disconnect from the transmission in the same manner.
  3. Disconnect the gearshift cables from the transmission.
    1. Lift the gearshift cables out of the cable bracket.
    2. Disconnect the gearshift cables from the transaxle gearshift control assembly.
    3. Remove the 2 gearshift cable clips.
      Fig 1: Removing Gearshift Cable Clips
      G03901892Courtesy of FORD MOTOR CO.
  4. Remove the 2 gearshift cable clips.
  5. Disconnect the 2 gearshift cables from the gearshift lever.
  6. Remove the 2 gearshift cable grommet nuts.
  7. Remove the gearshift cables.
scientia non olet · About LEMON Manuals