LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Transfer Case - Power Transfer Unit (PTU)) >> In-Vehicle Repair >> Output Shaft Seal >> Installation

Output Shaft Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Using the special tool, install the transfer case rear output shaft oil (pinion) seal.
    Fig 1: Installing Transfer Case Rear Output Shaft Oil
    G03901920Courtesy of FORD MOTOR CO.
  2. Install the transfer case rear output shaft flange. For additional information, refer to OUTPUT FLANGE .
scientia non olet · About LEMON Manuals