Removal and Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Throttle body bore and plate area have a special coating and cannot be cleaned, or possible damage to the throttle body can occur.
NOTE:
The electronic throttle body is serviced as a complete assembly. Individual components cannot be serviced.
- Remove the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - HYBRID .
- Disconnect the electronic throttle body coolant hoses.
- Disconnect the coolant hoses.
- Plug the coolant hoses.
- Disconnect the electronic throttle body electrical connector.
- Remove the 4 bolts and the electronic throttle body.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.
- Clean and inspect the electronic throttle body gasket, replace if necessary.