LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Electronic Engine Control System - 2.3L - (Except Hybrid)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal

Powertrain Control Module (PCM): Removal

WARNING: This page is about a different variant/trim than selected.
    NOTE: Any PCM replacement will require that ALL customer keys are available to be programmed at the time of installation. PCM replacement DOES NOT require new keys.
  1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the PCM stud bolt nut and position the wiring harness aside.
  4. Disconnect the 3 PCM electrical connectors.
  5. Remove the 2 stud bolts and the PCM.
  6. Remove the PCM cowl seal.
scientia non olet · About LEMON Manuals