LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Electronic Engine Control System - 2.3L - (Except Hybrid)) >> Removal And Installation >> Knock Sensor (KS) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the intake manifold. For additional information, refer to ENGINE - 2.3L .
  4. Remove the bolt and the knock sensor.
    • To install, tighten to 20 Nm (15 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals