LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Electronic Engine Control System - 2.3L - (Except Hybrid)) >> Removal And Installation >> Idle Air Control (IAC) Valve >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the 3 screws, the pin-type retainer and the upper and lower snow shield.
    • To install, tighten to 10 Nm (89 lb-in).
  3. Disconnect the idle air control (IAC) valve electrical connector.
  4. Remove the 2 bolts and the IAC valve.
    • To install, tighten to 4 Nm (35 lb-in).
    • Inspect the gasket and install new as necessary.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals