LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Electronic Engine Control System - 2.3L - (Except Hybrid)) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Detach the cylinder head temperature (CHT) sensor cover and position aside.
  3. Disconnect the CHT electrical connector.
  4. Remove and discard the CHT.
    • To install, tighten to 12 Nm (9 lb-ft)
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals