LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Electronic Engine Control System - 2.3L - (Except Hybrid)) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal

Crankshaft Position (CKP) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the 5 bolts and the RH splash shield.
  4. Remove the plug.
    Fig 1: Locating Plug
    G03900478Courtesy of FORD MOTOR CO.
  5. Turn the crankshaft pulley bolt to position the number one cylinder at top dead center and install the special tool.
    Fig 2: Identifying Special Tool
    G03897707Courtesy of FORD MOTOR CO.
  6. Disconnect the crankshaft position (CKP) sensor electrical connector.
  7. Remove the bolts and the CKP sensor.
scientia non olet · About LEMON Manuals