LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Electronic Engine Control System - 2.3L - (Except Hybrid)) >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the camshaft position sensor (CMP) sensor electrical connector.
  3. Remove the bolt and the CMP.
    • To install, tighten to 7 Nm (62 lb-in).
    • Inspect the O-ring seal and install new as necessary.
    4. NOTE: Lubricate the CMP O-ring seal with clean engine oil.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals