LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 920 (Full Frame And Body Mounting -- F250-F550 Super Duty) >> Removal And Installation >> Body Support - Rear, Regular Cab, Lower >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move the front seat forward.
  2. Move the front seatback forward.
  3. If equipped, remove the utility tray behind the seat. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  4. Pull the carpet or mat back to see the rear body insulator bolt head.
  5. Remove and discard the bolt.
    • To install, tighten to 80 N.m (60 lb-ft).
    6. Fig 1: Locating Bolt
    GF0005494Courtesy of FORD MOTOR CO.
  6. Remove the insulator.
    7. Fig 2: Locating Insulator
    GF0005493Courtesy of FORD MOTOR CO.
    NOTE: Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
    NOTE: No lubricants of any kind are to be used during body insulator installation.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals