LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 903 (Safety Belt System - F250-F550) >> Removal And Installation >> Safety Belt Shoulder Height Adjuster >> Removal And Installation >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Inspect the D-ring cover for damage. If the cover is damaged or does not remain closed, install a new D-ring cover.
  1. Open the D-ring cover.
  2. Remove the nut and the D-ring.
    • To install, tighten to 40 Nm (30 lb-ft).


  1. Remove the safety belt shoulder height adjuster cover.
  2. Remove the 2 bolts and the safety belt shoulder height adjuster.
    • To install, tighten to 40 Nm (30 lb-ft).
    3. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
  3. To install, reverse the removal procedure.
  4. Check the active restraint system for correct operation. For additional information, refer to Safety Belt System  in this article.
scientia non olet · About LEMON Manuals