Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear window. For additional information, refer to GLASS, FRAMES AND MECHANISMS article.
If equipped, remove the overhead console.
- Release the locking tabs while pulling down.
Remove the left and right visors.

Fig 1: Locating Left And Right Visors

Courtesy of FORD MOTOR CO.

Disconnect the electrical connectors.

Fig 2: Identifying Electrical Connectors

Courtesy of FORD MOTOR CO.

Remove the left and right visor arm clips.

Fig 3: Locating Left And Right Visor Arm Clips

Courtesy of FORD MOTOR CO.

Position the left and right front door opening weatherstrips down from the headliner.

Fig 4: Positioning Left And Right Front Door Opening Weatherstrips Down From Headliner

Courtesy of FORD MOTOR CO.

Remove the left and right windshield side garnish moulding. For additional information, refer toA-Pillar Trim Panel in this article.
Remove the rear B-pillar assist handles.
- Remove the 4 covers (2 on each handle).
- Remove the 4 screws (2 on each handle).
- Remove the 2 B-pillar assist handles.

Fig 5: Locating Rear B-Pillar Covers And Screws

Courtesy of FORD MOTOR CO.

If equipped, remove the rear and front passenger assist handles.
- Remove the covers and screws.
- Remove the rear assist handles.

Fig 6: Locating Rear And Front Passenger Assist Handles

Courtesy of FORD MOTOR CO.

Remove the left and right rear coat hooks.

Fig 7: Locating Left And Right Rear Coat Hooks

Courtesy of FORD MOTOR CO.

Remove the 2 courtesy lamps.
- Remove the courtesy lamp lens, then remove the screws.

Fig 8: Locating Courtesy Lamp Lens Screws

Courtesy of FORD MOTOR CO.

Remove 2 headliner front pin-type retainers.

Fig 9: Locating Headliner Front Pin-Type Retainers

Courtesy of FORD MOTOR CO.

Remove the 2 headliner rear pin-type retainers.

Fig 10: Locating Headliner Rear Pin-Type Retainers

Courtesy of FORD MOTOR CO.

CAUTION: If the safety belt retractor is to be reused, do not allow the safety belt to be retracted all the way into the retractor. Doing so may cause the retractor to lock and not release the safety belt.

NOTE: Inspect the shoulder safety belt guide and cover for damage. If the shoulder safety belt guide or cover is damaged or the cover does not remain closed, install a new shoulder safety belt guide.

Lift up on the cover and remove the front and rear seat nut and shoulder safety belt guides.
- To install, tighten to 40 N.m (30 lb-ft).

Fig 11: Locating Front And Rear Seat Nut And Shoulder Safety Belt Guides

Courtesy of FORD MOTOR CO.

Remove the front and rear door scuff plates.

Fig 12: Locating Front And Rear Door Scuff Plates

Courtesy of FORD MOTOR CO.

Position the B-pillar trim panels aside.

Fig 13: Positioning B-Pillar Trim Panels Aside

Courtesy of FORD MOTOR CO.

NOTE: The left front seat back must be fully reclined.

NOTE: Make sure not to damage the headliner when removing it from the vehicle.

Remove the headliner through the rear window opening.
To install, reverse the removal procedure.