LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 872 (Electronic Engine Controls - Gasoline Engine -- F250-F550 Super Duty) >> Removal And Installation >> Charge Motion Control Valve (CMCV) - 5.4L >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to ENGINE - 5.4L (3V) article.
  2. Disconnect the charge motion control valve (CMCV) RH and LH rods from the intake manifold.
    • Lubricate the CMCV RH and LH rod ends with clean engine oil prior to installation.
  3. Remove the stud bolt, the 2 bolts and the CMCV.
    • To install, tighten to 6 N.m (53 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals