LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 803 (Interior Trim And Ornamentation - F-150 & Mark LT) >> Removal And Installation >> B-Pillar Trim Panel - SuperCrew >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door scuff plate.
  2. Remove the B-pillar bolt cover.
  3. Remove the safety belt trim cover.
  4. Remove the B-pillar bolt.
  5. Remove the safety belt nut.
    • To install, tighten to 48 Nm (35 lb-ft).
  6. Remove the safety belt anchor bolt.
    • To install, tighten to 48 Nm (35 lb-ft).
  7. Remove the rear door scuff plate.
  8. Position the front seat forward.
  9. Pull the safety belt through the B-pillar trim panel.
  10. Remove the B-pillar trim panel.
  11. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals