LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 785 (Engine Cooling System - F-150 & Mark LT) >> Removal And Installation >> Block Heater >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Drain the engine cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding  in this article.
  3. Disconnect the block heater electrical connector.
    4. NOTE: Do not loosen the block heater retaining screw more than necessary for removal.
  4. Loosen the block heater retaining screw and remove the block heater.
    • To install, tighten to 2 Nm (18 lb-in).
    5. NOTE: Clean the engine block mating surface with metal surface prep. Follow the directions on the packaging.
  5. To install, reverse the removal procedure.
    • Route the block heater power cable away from hot or rotating components, or damage to the cable can occur.
scientia non olet · About LEMON Manuals