LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 784 (Fuel Charging And Controls - 5.4L (3V) - F-150 & Mark LT) >> Removal And Installation >> Fuel Pump Driver Module (FPDM) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Lower the spare tire.
  3. Disconnect the fuel pump driver module electrical connector.
  4. Remove the bolts and the fuel pump driver module (FPDM).
    • To install, tighten to 10 N.m (89 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals