LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 775 (Engine - 5.4L (3V) - F-150 & Mark LT) >> In-Vehicle Servicing >> Oil Pan >> Removal >> Four wheel drive (4WD) vehicles

Four wheel drive (4WD) vehicles

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position a suitable hydraulic jack under the front axle. Securely strap the jack to the axle.
    Fig 1: Identifying High-Lift Jack To Support Axle Assembly
    GF0002637Courtesy of FORD MOTOR CO.
    2. NOTE: Rotate the steering column so the pinch bolt for the steering column coupling allows clearance for the isolator bolt.
    Fig 2: Identifying Upper Mounting Bushing Bolt
    GF0002638Courtesy of FORD MOTOR CO.
  2. Remove the upper front axle carrier mounting bushing bolt.
  3. Remove the axle shaft housing carrier bushing bolt.
    Fig 3: Identifying Axle Tube Bushing Nut And Bolt
    GF0002639Courtesy of FORD MOTOR CO.
  4. Remove the lower front axle carrier mounting bushing bolt.
    Fig 4: Identifying Lower Mounting Bushing Bolt
    GF0002640Courtesy of FORD MOTOR CO.
    5. CAUTION: Use care when lowering the front axle housing, or the vacuum lines to the axle solenoid may become disconnected or damaged.
    Fig 5: Lowering Axle To Allow Clearance For Oil Pan To Be Removed
    GF0002773Courtesy of FORD MOTOR CO.
  5. Lower the axle to allow clearance for the oil pan to be removed.
scientia non olet · About LEMON Manuals