LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 775 (Engine - 5.4L (3V) - F-150 & Mark LT) >> In-Vehicle Servicing >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the engine cooling fan shroud. For additional information, refer to ENGINE COOLING article.
  3. Rotate the tensioner clockwise and remove the accessory drive belt.
    Fig 1: Rotating Tensioner Clockwise And Removing Accessory Drive Belt
    GF0000336Courtesy of FORD MOTOR CO.
  4. Remove the crankshaft pulley bolt and washer.
    • Discard the crankshaft pulley bolt.
  5. Using the special tool, remove the crankshaft pulley.
    Fig 2: Removing Crankshaft Pulley Using Special Tool
    G03919906Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals