LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Automatic Transmission -- F250-F550 Super Duty) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Transmission Overheating

Transmission Overheating

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC ROUTINES - TRANSMISSION OVERHEATING

Possible Component Reference/Action
260 - ROUTINE 
Powertrain Control System   
NOTE: FMEM may be enabled, refer to routine 266. PCM, vehicle wiring harnesses, line pressure control solenoid PC-A, TCC solenoid
 
 
  • Repair as required. Clear DTCs, road test and rerun on-board diagnostic test.
Fluid   
  • Incorrect level
Transmission External Remote Filter   
 
  • Inspect for leakage. If damaged, repair as necessary.
Fluid Pump Assembly   
  • Bolts not tightened to specification
  • Tighten to specification.
  • Gasket damaged
  • Inspect for damage. If damaged, install a new gasket.
  • Porosity, cross leaks, cup plug missing, plugged hole gears cracked or seized
  • Inspect for damage. If damaged, repair as necessary.
  • Control valves and springs or seal damaged, misassembled or stuck
  • If damaged or parts are missing, install a new seal or pump assembly. If misassembled, reassemble correctly.
Transmission Case   
  • Case vent damaged
  • Inspect for damage. If damaged, repair as necessary
Torque Converter   
  • Torque converter one-way clutch seized
  • Remove the transmission. Inspect for damage. Refer to TORQUE CONVERTER  in the General Procedures portion of this article. If the torque converter fails to pass the criteria for replacement or is damaged, install a new or remanufactured torque converter.
  • Excessive torque converter slip detected
  • Remove the transmission. Inspect for damage. Refer to TORQUE CONVERTER  in the General Procedures portion of this article If the torque converter fails to pass the criteria for replacement or is damaged, install a new or remanufactured torque converter.
Other   
  • Restriction in transmission cooling system
  • Excessive trailer tow load
  • Refer to the towing manual.
  • Engine driveability concerns
  • Vehicle heat shields missing or damaged
  • Inspect for damage. If damaged, repair as necessary.
  • Vehicle air flow restricted
  • Inspect for damage. If damaged, repair as necessary.