LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 587 (Warning System -- F250-F550 Super Duty) >> Diagnosis And Testing >> Warning Devices >> Pinpoint Test D: The Chime Sounds When The Driver Door Is Ajar (No Key In The Ignition And Headlamps Off) >> Pinpoint Test D: The Chime Sounds When The Driver Door Is Ajar (No Key In The Ignition And Headlamps Off)

Pinpoint Test D: The Chime Sounds When The Driver Door Is Ajar (No Key In The Ignition And Headlamps Off)

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. D1 CHECK FOR INSTRUMENT CLUSTER DTCs 
    • Check the recorded DTCs from the instrument cluster self-test.
    • Is DTC B1352 present? 

    Yes  : Go to PINPOINT TEST A .

    No  : Go to D2.

  2. D2 CHECK FOR CORRECT INSTRUMENT CLUSTER ILLUMINATION OPERATION 
    • Check the instrument cluster illumination.
    • Is the instrument cluster illumination operating correctly? 

    Yes  : Go to D3.

    No  : REFER to INSTRUMENT CLUSTER AND PANEL ILLUMINATION to continue diagnosis of the instrument cluster illumination.

  3. D3 CHECK FOR CORRECT INSTRUMENT CLUSTER OPERATION 
    • Disconnect all the instrument cluster connectors.
    • Check for:
      • corrosion
      • pushed-out pins
    • Connect all the instrument cluster connectors.
    • Operate the system and verify the concern is still present.
    • Is the concern still present? 

    Yes  : INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . TEST the system for normal operation.

    No  : The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.