LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine - 6.8L (3V) -- F250-F550 Super Duty) >> In-Vehicle Repair >> Camshaft Roller Follower >> Installation

Camshaft Roller Follower: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All camshaft roller followers 

    CAUTION: If the components are to be reinstalled, they must be installed into their original locations.
    NOTE: Lubricate the camshaft roller followers with clean engine oil prior to installation.
    Fig 1: Compressing Valve Spring With Special Tool
    G03919946Courtesy of FORD MOTOR CO.
  1. Using the special tool, compress the valve spring and install the camshaft roller follower.
  2. Repeat the previous step for each camshaft roller follower being serviced.

    3. Cylinder No. 7 front intake valve roller follower 

  3. Position the camshaft bearing cap and install the 2 bolts.
    • Tighten to 10 Nm (89 lb-in).
      Fig 2: Identifying Bolts And Camshaft Bearing Cap
      G03920703Courtesy of FORD MOTOR CO.

    4. Cylinder No. 10 front intake valve roller follower 

  4. Position the camshaft bearing cap and install the 2 bolts.
    • Tighten to 10 Nm (89 lb-in).
      Fig 3: Identifying Bolts And Camshaft Bearing Cap
      G03920706Courtesy of FORD MOTOR CO.

    5. All camshaft roller followers 

  5. Depending on the valve being serviced, install the LH or RH valve cover. For additional information, refer to VALVE COVER - LH  or VALVE COVER - RH .
scientia non olet · About LEMON Manuals